SKF Microlog GX Series - Page 339

measurement setup A-17
triax 4-28, A-21
two channel spectrum A-18
two channel spectrum/time A-20
two channel time A-19
multi time waveform
measurement setup A-17
multi-channel measurements 4-19
multi-point automation See MPA
measurements
mute 11-10
N
non-route
function buttons A-2
pre-set measurements A-3
review A-25
triax displays 4-28, A-21
two channel spectrum A-18
two channel spectrum/time A-20
two channel time A-19
user screen A-10
user-defined measurements A-10
normalization 11-4, 11-16
note button 11-17
notes, coded 3-22
number of bands 9-13
number of components 5-7
Nyquist plot 7-11
display 7-12
setup 7-11
O
operator, selecting 3-3
opposite, pre-set measurement A-3
orbit 4-19, A-5
data collection A-8
data review 3-30
overview 4-29, A-5
route mode 3-18
setup A-6
setup screen A-6
orbit setup A-6
coupling A-6
ext. trigger slope A-7
level A-7
sensitivity A-7
trigger A-7
units A-6
overall vibration 6-3
overlap 4-11, A-14
overload
clearing 3-25
signal 3-25
P
parabolic reflector 11-6
pause recording 6-4
peak cursor 3-14
phase 4-7, 4-10
phase tables A-24
phase, cross channel A-22
pickup 3-24
picture 9-18, 10-4
point information A-26
polar 5-10
polar correction 5-7
post-process 6-1
power button 1-14
power cycle, automatic 1-14, 3-13
power spectrum 4-5
power supply/battery charger 1-19, 1-20
pre-set measurements A-3
acceleration A-4
acceleration-time A-4
enveloped acceleration A-5
hfd A-5
high resolution A-3
opposite A-3
orbit A-5
same A-3
velocity A-4
printing
from display 4-16, 10-24
screens 1-18
test results 4-16, 10-24
process measurements
data collection 3-19
manual data entry 3-21
review 3-34
review screen 3-34
processing time - RUCD 7-2
prognosis 5-3, 5-38
message 5-43
pulses/rev 7-5
purchase modules 1-12
SKF Microlog - GX Series Index - 5
User Manual