R
recall 5-3, 6-2, 7-3, 7-26, 8-4, 8-7, 11-12
recalling a setup 11-19
recorder
overview 6-1
preview mode 6-3
recording mode 6-8
recording time 6-8
recording, pause 6-4
reference point, speed 3-23
reset, hard 1-28
resolution 4-11
resume mode 1-14
resume recording 6-4
review 3-28
dynamic measurements 3-28
historical data 3-32
MPA measurements 3-31
non-route A-25
orbit data 3-30
process measurements 3-34
spectral display screen 3-28, A-26
three channel in route 3-31
triax in route 3-31
two channel in route 3-31
review meas. 7-26
review process screen 3-34
reviewing test results 10-24
rotor mass 5-14
route 3-1
delete all 2-5
font 2-5
function buttons 3-6
hierarchy 3-4
hierarchy list navigation 3-5
multi channel data 3-17
orbit data 3-18
route module 3-1
status 3-9
RPM
1x RPM 3-12
RUCD
led 7-4
mode 7-5
processing time 7-2
setup 7-4
start - stop speed 7-5
state 7-6
taking data mode 7-6
run-up coast-down 6-1, 7-1
S
same, pre-set measurement A-3
samples/lines A-13
save
meas. results 4-14
meas. setup 4-12, 4-14, 4-22, 4-32, 4-36,
4-38
save button 11-14
saving meas. 7-26
saving screens 1-18
saving settings 11-14
saving test results 9-21, 10-23
saving test template 9-16
scroll columns 9-20, 10-6
SD card 1-9, 1-27, 4-17, 6-7, 7-5, 8-7,
10-25, 11-21
operation 1-27
printing screens 1-18
selecting operators 3-3
sensitivity A-13
sensor
disconnecting 3-10, 3-25
orientation 9-7, 9-15
setup 2-10
type 4-9
variable 4-9
sensor setup screen 2-10
sensor type
conf. checker 9-6
serial number 1-12
settling 2-8
delay 2-8
setup screen 2-1, 2-2
date format 2-5
date/time 2-5
default units 2-2
memory 2-5
route memory 2-2
timeout 2-2
setup, balancing 5-4
shift button 1-14, 1-17
shift key 2-1
show icons 1-10, 1-11
SKF title screen 1-9, 1-14, 10-2
skip function button 9-19, 10-6
skip test position 9-19, 10-6
software
Index - 6 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
