Xerox WorkCentre 6605

Error Troubleshooting
Phaser 6600 and WorkCentre 6605 Xerox Internal Use Only
Service Manual
2-32
Dew Prevention
You can specify whether to set the Dew Prevention mode to ON or OFF.
Procedure
1. Enter Service Mode. See “How To Enter Service Mode” on page 2-8.
2. Confirm that the [Printer Diag] is selected, and then press the OK button.
3. Use the [ ] button to select [Engine Diag], and press the OK button.
4. Use the [ ] button to select [Dew Prevention], and press the OK button.
5. Use the [ ] or [ ] button to switch to ON or OFF, and press the OK button.
6. Press the Back button to return to the [Printer Diag] screen.
7. Exit Service Mode. See “How to Exit Service Mode” on page 2-10.
Initial IU
Procedure
1. Enter Service Mode. See “How To Enter Service Mode” on page 2-8.
2. Confirm that the [Printer Diag] is selected, and then press the OK button.
3. Use the [ ] button to select [IOT Diag], and press the OK button.
4. Use the [ ] button to select [Initial IU], and press the OK button.
5. Use the [ ] or [ ] button to select [Disable] or [Enable], and press the OK button to confirm the
setting.
Printer Diag
Engine Diag
Engine Diag
Sensor Test
Engine Diag
Dew Prevention
Dew Prevention
OFF *
Dew Prevention
ON
Printer Diag
Engine Diag
Printer Diag
Engine Diag
Engine Diag
Sensor Test
Engine Diag Initila IU
Initila IU
Enable