Xerox WorkCentre 6605

Image Quality
Phaser 6600 and WorkCentre 6605 Xerox Internal Use Only
Service Manual
3-4
Image Quality FIP
This section describes the following image quality problems:
• The output is too light - 3-5
• Toner smears or print comes off - 3-7
• Random spots/Blurred images - 3-8
•Blank output - 3-9
• Streaked output - 3-11
• Partial or entire black output - 3-12
•Pitched color dots - 3-13
• Vertical blanks - 3-14
• Ghosting - 3-15
• Light-induced fatigue - 3-16
• Fog - 3-17
•Bead-Carry-Out (BCO) - 3-18
• Jagged characters - 3-18
•Banding - 3-19
• Auger mark - 3-20
• Wrinkled/Stained paper - 3-20
• Leading edge paper damage - 3-22
• Incorrect top and side margins - 3-23
• Color registration is out of alignment - 3-24
• Images are skewed - 3-25