Xerox WorkCentre 6605

Service Parts Disassembly
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
4-61
550 Option Regi Clutch Assembly
PL10.2.2
1. Remove the Optional 550-Sheet Feeder from the printer. (page 4-53)
2. Remove the 550 Option Main Feed Assembly. (page 4-60)
3. Pull out the 550 Option Feeder Gear together with the shaft.
4. Remove the screw (silver, tapping, 8mm) that attaches the Nudger 2 Spring Bracket to the printer
and remove the bracket.
5. Release the harness coming out of the 550 Option Regi Clutch Assembly from the harness guide.
6. Remove the E-ring holding the the 550 Option Regi Clutch Assembly, and then pull the clutch
Assembly off of the shaft.
Replacement Note: When installing the 550 Option Regi Clutch Assembly, align the recess on the
clutch Assembly with the lug on the frame.
s6600-124