EasyManuals Logo

Xerox WorkCentre 6605 Service Manual

Xerox WorkCentre 6605
662 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
General Information
Xerox Internal Use Only Phaser 6600 and WorkCentre 6605
Service Manual
1-43
Fuser (PL7.1.1)
The Fuser is a unit that fuses the complete toner image transferred on the sheet with the sheet by heat
and pressure. The Fuser consists of the following components.
• Heat Roller — A spouted metal Roller, which has the surface for giving heat to fuse toner on a
sheet covered by the tube.
• Pressure Belt — A belt contained the pressurization system inside. Paired up with the Heat Roller,
impresses toner on the sheet.
• Heater Lamp — A lamp that seals the heat coil as a heat source in the Heat Roller and that is
stored inside the Heat Roller. A heating element that heats up the Heat Roller.
• Center Temp. Sensor (contactless type) — A thermistor as an electric resistor that reacts
corresponding with temperature changes, located in the Hear Roller contactlessly, and detects the
surface temperature on the Heat Roller. Based on the temperature detected, controls ON (power
distribution: lighting) / OFF (Extinction).
• Rear Temp. Sensor (contact type) — A thermistor as an electric resistor that reacts corresponding
with temperature changes, located in contact with the Heat Roller, and detects the surface
temperature on the Heat Roller. Prevents the abnormally high temperature of the Heat Roller.
• Thermostat — Located in series with the power source of the Heater Lamp, and prevents the
secondary excess rise of temperature by the open interface when the temperature excess rise
preventions (primary) by Temp. Sensor (thermistor) fails and temperature on the interface part
reaches to a certain level.
• First Time Fuse — Resets page count on fuser installation.

Table of Contents

Other manuals for Xerox WorkCentre 6605

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Xerox WorkCentre 6605 and is the answer not in the manual?

Xerox WorkCentre 6605 Specifications

General IconGeneral
FunctionsPrint, Copy, Scan, Fax
Print TechnologyLaser
Print ResolutionUp to 600 x 600 x 4 dpi
Copy ResolutionUp to 600 x 600 dpi
Scan ResolutionUp to 600 x 600 dpi
Fax Speed33.6 Kbps
Standard Paper Capacity550 sheets
Maximum Paper Capacity1, 250 sheets
Paper Output250 sheets
Duplex PrintingYes
Processor533 MHz
Memory (Standard)512 MB
Memory (Maximum)1 GB
Monthly Duty CycleUp to 80, 000 pages
TypeMultifunction
Copy SpeedUp to 36 cpm black and color
Fax Resolution300 x 300 dpi
Media SizesLetter, Legal, A4, A5, B5, Custom sizes
ConnectivityUSB 2.0, Ethernet
Mobile PrintingApple AirPrint
Operating System CompatibilityWindows, Mac, Linux
Dimensions (W x D x H)500 mm
Weight29.6 kg
Print SpeedUp to 36 ppm (Black) / Up to 36 ppm (Color)

Related product manuals