Atlas Copco Power Focus 3000 User Manual

Digital I/O and fieldbus items
9836 3123 01 317 (428)
Name
Description
Fieldbus items
Duration
Tensor ST/SL
String
length
Value
Set signal
/ Reset signal
Time
To next tightening
Tracking
Blue LED
Sound (time duration for all)
Illuminator
TLS ST Tag LED
Pset Target
Angle
Show Pset
parameter P123
Target angle.
2 bytes
U16
New Pset selected
or updated / No
signal. On until
new Pset is selected
or current Pset
updated
PVT
compensate
Indicates PVT
compensate
4 bytes
Fixed point
2 bytes
integer part
and 2 bytes
decimal part
Tightening result /
Start new
tightening or new
Pset selected or
new Job selected
PVT mon
status / Run
down angle
status /
PVT
selftap
status /
Current
status
Status on one of the
result parameters
PVT mon,
Rundown angle,
PVT selftap or
Current.
1 byte ASCII
character
O = OK
L = Low
H = High
Tightening result /
Start new
tightening or new
Pset selected or
new Job selected
2 bits
BF
00 = Not used
01 = OK
10 = High
11 = Low
PVT mon
status
HIGH /
Run down
angle status
HIGH /
PVT
selftap
status
HIGH /
Current
status
HIGH
Result is above max
limit. There are
three different
variables in the
setup.
1 bit
0 = Not used
1 = High
Tightening result /
Start new
tightening or new
Pset selected or
new Job selected

Atlas Copco Power Focus 3000 Specifications

General

Brand	Atlas Copco
Model	Power Focus 3000
Category	Control Systems
Language	English