viii
Fixed value output 4-22
Special control output 4-23
When switching to MANUAL mode 4-23
PID control initialization 4-24
PID initial MV 4-24
MV change limit 4-25
PID control 4-25
AT (Auto-tuning) 4-26
SP lag 4-26
ON/OFF control 4-27
4 - 5 AT (Auto-tuning) 4-28
How to start 4-28
How to stop AT 4-28
4 - 6 SP 4-31
Setting the LSP from the 1-loop monitor screen 4-32
Selecting LSP group and RSP from the 1-loop monitor screen 4-32
Number of LSP system groups 4-32
RSP setting 4-32
LSP1 to 8 and RSP 4-33
PID group number 4-33
LSP group No. 4-34
DI assignment for LSP group selection 4-34
SP ramp unit 4-35
SP ramp up and down slopes 4-36
SP low and high limits 4-37
RSP tracking 4-37
4 - 7 Pattern Operation 4-38
Number of patterns 4-39
Time unit for patterns 4-39
Number of segments 4-39
SP/Time 4-39
PID group number 4-41
G.SOAK (guaranteed soak) 4-41
Segment event 4-43
PV start 4-43
Cycle 4-44
Pattern link 4-44
End of operation 4-45
Pattern start number 4-46
Pattern SP increase/decrease change limit 4-47
4 - 8 DI (Digital Input) 4-49
DI/DO configuration 4-49
DI assignment 4-50
4 - 9 Events 4-55
Operation 4-56
Operation type and Loop definition 4-61
Direct/reverse, Standby, and READY mode operation 4-62
Event main setting, event subsetting, hysteresis, delay 4-64
To Next Page
Loading...
