Azbil C7G

14-5
Chapter 14. Appendix

PP (position proportional) output process block diagram
Control method selection
Auto-tuning
Position proportional
CLOSE output
terminal
OPEN output
terminal
Dead zone
Motor drive output
Execute auto-tuningStop auto-tuning
Manual adjustment
Fully closed MFB count,
Fully open MFB count,
Full opening time
Output type: OFF
MFB opening calculation
(including estimation)
Output types:
MV, Heat MV,
Cool MV for loops 1 to 2
Output types:
Standard values*
Standard value:
MFB count
Switch by output type
Linearization
Standard bit:
MFB input error
Standard value:
MFB opening
(actual value)
MFB opening
(estimated value)
MFB opening actual
measurement
MFB opening
estimation
Standard bit:
Estimating MFB
Standard value:
MFB opening
(including estimation)
Standard bit:
Motor drive output
CLOSE
Standard bit:
Motor drive output
OPEN
Standard bit:
MFB in auto-tuning
Standard bit:
MFB adjustment error
Linearization
* Output type “2048:0.0 (fixed value)” is included in the standard numerical codes.