Azbil C7G

4-14
Chapter 4. Functions

RUN/READY mode
You can switch between the RUN and READY modes for each control loop in the
constant value operation mode.

RUN → READY
(1) Press the [] (mode) button on the 1-loop monitor screen.
> The mode selection screen appears.
(2) Press the [RUN] button in the right side of RUN/READY.
> The confirmation screen for changing the mode to READY appears.
(3) Press the [READY] button.
> The mode changes to READY.

READY → RUN
(1) Press the [] (mode) button on the 1-loop monitor screen.
> The mode selection screen appears.
(2) Press the [READY] button in the right side of RUN/READY.
> The confirmation screen for changing the mode to RUN appears.
(3) Press the [RUN] button.
> The mode changes to RUN.
Handling Precautions
• The master side of the internal cascade control is fixed in RUN mode.

LSP/RSP mode
You can switch between the LSP and RSP modes for each control loop.

LSP → RSP
(1) Press the [SP] button on the 1-loop monitor screen.
> The SP change screen appears.
(2) Press the Change button on the right side of LSP/RSP.
> The LSP/RSP selection screen appears.
(3) Press the [RSP] button.
> The mode is switched to RSP.

RSP → LSP
(1) Press the [SP] button on the 1-loop monitor screen.
> The SP change screen appears.
(2) Press the Change button on the right side of LSP/RSP.
> The LSP/RSP selection screen appears.
(3) Press any of the LSP1 to 8 buttons.
> The mode is switched to LSP.