4-120
Chapter 4. Functions
(3) Touch panel test 1 screen
Touch the center of the "+" mark shown in the upper left.
>> If touch panel test 1 is successful, the Touch panel test 2 screen appears.
If the test fails, the screen returns to Touch panel calibration 1 of step 1, and
it must be readjusted.
(4) Touch panel test 2 screen
Touch the center of the "+" mark shown in the lower right.
>> If touch panel test 2 is successful, the Monitor screen is displayed again.
If the test fails, the screen returns to the screen for step 1, and adjustment
must be performed again.
Handling Precautions
• Since positional adjustment must be performed precisely, it is better to use a
touch pen than your finger.
• To quit in the middle of positional adjustment, press the Home button.
• After exiting in the middle of positional adjustment, adjustment is invalidated
and the screen returns to its status before adjustment.
To Next Page
Loading...
