Quilting
112
Using Free Motion Quilting Foot
“C”
Use free motion quilting foot “C” with the straight
stitch needle plate for free-motion sewing with
straight stitches.
1 Turn off the machine and remove the
needle plate. (page 255)
a Round hole
2 Select a stitch.
3 Touch then to set the machine to
free motion sewing mode.
a Free motion quilting foot “C”
4 Remove the presser foot holder.
(page 48)
5 Attach free motion quilting foot “C” as
shown the illustration and tighten the
presser foot holder screw.
a Presser foot holder screw
b Notch
6 Use both hands to stretch the fabric taut,
and then move the fabric at a consistent
pace in order to sew uniform stitches
roughly 2.0-2.5 mm (approx. 1/16 - 3/32
inch) in length.
a Stitch
7 Touch to cancel the free motion
sewing mode.
8 After sewing, make sure to remove the
straight stitch needle plate and presser
foot “C”, and reinstall the regular needle
plate.
CAUTION
• When using free motion quilting foot “C”, be sure to use
the straight stitch needle plate and sew with the needle
in middle (center) needle position. If the needle is moved
to any position other than the middle (center) needle
position, the needle may break, which may result in
injuries.
• Make sure that the free motion quilting foot “C”
is attached properly and not slanted.
CAUTION
• Be sure to securely tighten the screw with the included
multi-purpose screwdriver. Otherwise, the needle may
touch the quilting foot, causing it to break and causing
injury.
• Free motion open toe quilting foot “O” can also
be used with the straight stitch needle plate.
We recommend using free motion open toe
quilting foot “O” with free motion sewing of
fabrics of uneven thicknesses.
To Next Page
Loading...
