Brother EV1 - Assembling the Spool Stand; Using the Spool Stand

Upper Threading
Getting Ready
45
1
15 Raise the presser foot and pull out about
10 cm (approx. 4 inches) of the thread,
and then pass it under the presser foot
toward the rear of the machine.
a About 10 cm (approx. 4 inches)
The included spool stand is useful when using
thread spools with a large diameter (cross-wound
thread).
a Spool stand
b Spool cap (XL) × 2
c Spool holder × 2
d Spool cap base × 2
e Spool felt × 2
f Ring × 4
* No.2 to No.6 are included in a plastic bag.
 Assembling the Spool Stand
1
Hold in the tabs on the spool stand and
remove the lid.
2 Fully extend the telescopic thread guide
shaft until the two internal stoppers snap
into place.
Raise the spool pins.
a Telescopic thread guide shaft
b Spool pins
Memo
• If the needle could not be threaded or the
thread was not passed through the needle bar
thread guides, perform the procedure again
starting from step
3.
Note
• When using a needle or thread that cannot be
used with a needle threader, manually pass
the thread through the eye of the needle from
the front.
a
Using the Spool Stand