Create the Pattern Using Scanned Images or Image Data Files
245
My Design Center
6
Custom patterns can be created from drawings.
You can create patterns by scanning your
drawings or importing an image data file.
Recommended line drawings for Line
Conversion
• Line drawings must be drawn clearly using
lines with approximately 1 mm thickness.
• Line drawings should be drawn in a strong
contrast.
• If the lines are too short or gathered too
densely, they will not be converted correctly.
1 Touch .
2 Touch [Line design].
3 When scanning using the scanning frame
or the embroidery frame, touch [Scan].
When importing an image data file, select
the device you saved the data to.
* If two USB media are connected to the machine,
check the USB media names that are displayed,
and then touch the name of the USB media that
you wish to use.
a When this key is touched, the message to start
scanning appears. Touch [OK] to start scanning.
b The most recently scanned image is automatically
stored in the machine’s memory. Touch this key to
import the scanned image.
c Touch to import the data file saved on a USB
media. Save data as a .jpg, .bmp, or .png file type,
on a USB media. For details on files that can be
imported, refer to “Specifications” on page 271.
d Touch to transfer an image that was saved on the
smart device then sent to the machine. (page 226)
4 Move to frame the image for the
pattern. And then touch [OK].
a Adjust the image detection level.
b Changes the line color and stitch type. (page 233)
Create a Pattern with Line
Conversion
• For details on creating patterns using color
illustrations, refer to “Create a Pattern with
Illustration Conversion” on page 247.
• When converting a scanned/imported
background image to be displayed on the
screen, skip step
3 and proceed to step 4.
To Next Page
Loading...
