Brother EV1 - Changing the Screen Saver Image; Selecting the [Eco Mode] or [Shutoff Support Mode]

LCD Screen
Getting Ready
27
1
 Selecting the [Eco Mode] or
[Shutoff Support Mode]
You can save the machine power by setting the
[Eco Mode] and the [Shutoff Support Mode].
If you leave the machine without using for a
specified period of time, the machine enters into
one of these modes. Touch to display [Eco
Mode] and [Shutoff Support Mode]. (page 23)
[Eco Mode];
Machine will enter a sleep mode. Touch the screen
or press the “Start/Stop” button to continue
operating.
[Shutoff Support Mode];
Machine will enter the lower power mode after set
period of time. Turn machine off and then back on
to restart operating.
 Changing the Screen Saver Image
Instead of the default image, you can select your
own personal images for the screen saver of your
machine.
For details on compatible image files, refer to
“Specifications” on page 271.
1 Touch to display [Screen Saver] of the
settings screen.
2 Touch [Select], and then touch
[Customize].
3 Connect the USB media that contains
your personal image to the USB port of
the machine.
4 Touch [Change] to select the first image.
* Touch [Delete] to delete the selected image.
5 Touch the device that is connected.
* If two USB media are connected to the machine,
check the USB media names that are displayed,
and then touch the name of the USB media that
you wish to use.
6 Touch a file name to select image. Touch
[Set] and then touch [OK].
Memo
• If you turn off the machine while the machine
is in the [Eco Mode] or the [Shutoff Support
Mode], wait for about 5 seconds before turning
on the machine again.
• For details on condition of the [Eco Mode] and
[Shutoff Support Mode], refer to
“Specifications” on page 271.
Memo
• Touch [Default] to select default images for the
screen saver.