Embroidering Patterns
140
1 Prepare embroidery thread colors as
shown on the screen.
a Embroidery color order
2 Using the automatic needle threader,
thread the machine for the first color.
3 Lower the embroidery foot, then press
the “Start/Stop” button to start
embroidering.
When the first color is completely embroidered, the
machine will stop.
On the embroidery color order display, the next
color will move to the top.
4 Remove the thread for the first color from
the machine. Thread the machine with
the next color.
Embroidering Patterns
• Either the thread color name or the thread
number appears in this screen, depending on
the setting selected in the settings screen. You
can also select a thread brand. (page 25)
• The automatic thread cutting function and the
thread trimming function can be used.
(page 141)
• A setting in the settings screen can be
specified so that pressing the “Start/Stop”
button before starting embroidering
automatically lowers the embroidery foot.
(page 25)
• If you want to get more attractive finishes, try
the procedures below;
- After 5-6 stitches, press the “Start/Stop”
button again to stop the machine.
- Trim the excess thread at the beginning of
embroidering. If the thread at the beginning
of embroidering is under the embroidery
foot, raise the embroidery foot, then trim the
excess thread.
• If there is thread left over from the beginning of
embroidering, it may be embroidered over as
you continue embroidering the pattern, making
it very difficult to deal with the thread after the
pattern is finished. Trim the threads at the
beginning of each thread change.
To Next Page
Loading...
