Sewing
58
The machine can be set to automatically cut the
threads at the end of the stitching. If automatic
thread cutting is set, automatic reverse/
reinforcement stitching is also set.
1 Select a stitch pattern.
2 Touch to set the automatic thread
cutting function.
The keys will display as , and the machine
is set for automatic thread cutting function and
automatic reverse/reinforcement stitching.
3 Set the needle in the start position, and
press the “Start/Stop” button.
The machine will automatically sew reverse
stitches (or reinforcement stitches) and then
continue sewing.
4 Once you have reached the end of the
stitching, press (Reverse stitch
button) or (Reinforcement stitch
button) once.
If stitching, such as buttonholes and bar tacking, that
includes reinforcement stitching has been selected,
this operation is unnecessary.
After the reverse stitching (or reinforcement
stitching) has been done, the machine stops, and
the threads are cut.
a The point where the “Start/Stop” button was
pressed.
b The point where (Reverse stitch button) or
(Reinforcement stitch button) was pressed.
c The thread is cut here.
By setting the machine to automatically raise and
lower the presser foot, sewing operations can be
performed more smoothly. Touch to display
[Automatic Presser Foot Lift] of the settings
screen.
a When set to on, pressing the “Start/Stop” button or
depressing the foot controller automatically lowers
the presser foot (if it is raised) before starting to
sew.
b When set to on, pressing (Thread cutter
button) automatically lowers the presser foot (if it is
raised) before cutting the thread. The presser foot
will be raised after the thread is cut.
Automatic Thread Cutting
• To turn off the automatic thread cutting
function, touch again.
Automatic Presser Foot Lift
Function
32
1
To Next Page
Loading...
