Upper Threading
Getting Ready
47
1
Thread the Machine Using the
Spool Stand
1
Attach the spool stand to the machine.
(page 45)
2 Place the spool of thread on the spool pin
so that the thread feeds off the spool
clockwise. Firmly insert the spool cap
onto the spool pin.
3 Pull the thread off the spool. Pass the
thread from the back to the front through
the thread guides at the top.
4 Pass the thread through the machine’s
thread guide from the right to the left.
a Thread guide
5 Thread the machine according to steps 6
through
15 of “Upper Threading” on
page 42.
CAUTION
• Make sure that the spools do not touch each other,
otherwise the thread will not feed off smoothly, the
needle may break and cause injury. In addition, make
sure that the spools do not touch the telescopic thread
guide at the center.
• When using 2 spools of thread, make sure that
both spools are feeding in the same direction.
• Make sure that the thread is not caught under
the spool.
• Guide the thread so that it does not become
entangled with the other thread.
• After feeding the thread as instructed, wind
any excess thread back onto the spool,
otherwise the excess thread will become
tangled.
• When using thread that quickly feeds off the
spool, such as metallic thread, use the
enclosed ring to prevent the thread from
becoming entangled. Threading sequence:
Pull the thread from the spool, place the
thread through the ring from the bottom up
(1), into the thread guide (2) and through the
ring from the top down (3). When using the
ring, do not use the spool cap base.
To Next Page
Loading...
