Cisco SPS2024 - Sntp Unicast Client Poll

Clock Commands
sntp unicast client poll
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 115
6
sntp unicast client poll
The sntp unicast client poll Global Configuration mode command enables polling
for the Simple Network Time Protocol (SNTP) predefined Unicast servers. Use the
no form of this command to disable the polling for SNTP client.
Syntax
sntp unicast client poll
no sntp unicast client poll
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
User Guidelines
Polling time is determined by the sntp client poll timer Global Configuration mode
command.
Example
The following example enables polling for SNTP predefined Unicast clients.
Console(config)# sntp unicast client poll