Cisco SPS2024 - Radius-Server Deadtime

RADIUS Commands
radius-server deadtime
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 312
24
radius-server deadtime
The radius-server deadtime Global Configuration mode command improves
RADIUS response time when servers are unavailable. The command is used to
cause the unavailable servers to be skipped. Use the no form of this command to
restore the default configuration.
Syntax
radius-server deadtime deadtime
no radius-server deadtime
Parameters
•
deadtime — Length of time in minutes during which a RADIUS server is
skipped over by transaction requests. (Range: 0-2000)
Default Configuration
The deadtime setting is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets all RADIUS server deadtimes to 10 minutes.
Console(config)# radius-server deadtime 10