RMON Commands
show rmon log
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 331
25
The following table describes significant fields shown in the example:
show rmon log
The show rmon log Privileged EXEC mode command displays the RMON log table.
Syntax
show rmon log [
event
]
Parameters
•
event
— Specifies the event index. (Range: 0-65535)
Default Configuration
This command has no default configuration.
Field Description
Index An index that uniquely identifies the event.
Description A comment describing this event.
Type The type of notification that the device generates
about this event. Can have the following values:
none, log, trap, log-trap. In the case of log, an entry
is made in the log table for each event. In the case
of trap, an SNMP trap is sent to one or more
management stations.
Community If an SNMP trap is to be sent, it is sent to the SNMP
community specified by this octet string.
Owner The entity that configured this event.
Last Time Sent The time this entry last generated an event. If this
entry has not generated any events, this value is
zero.
To Next Page
Loading...
