QoS Commands
qos map policed-dscp
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 295
23
qos map policed-dscp
The qos map policed-dscp Global Configuration mode command modifies the
policed-DSCP map for remarking purposes. Use the no form of this command to
restore the default map.
Syntax
qos map policed-dscp
dscp-list
to
dscp-mark-down
no qos map policed-dscp
Parameters
•
dscp- list
— Specifies up to 8 DSCP values separated by a space. (Range:
0-63)
•
dscp-mark-down
— Specifies the DSCP value to mark down. (Range: 0-63)
Default Configuration
The default map is the Null map, which means that each incoming DSCP value is
mapped to the same DSCP value.
Command Mode
Global Configuration mode.
User Guidelines
DSCP values 3,11,19… cannot be remapped to other values.
Example
The following example marks down incoming DSCP value 3 as DSCP value 43 on
the policed-DSCP map.
Console(config)# qos map policed-dscp 3 to 43
Reserved DSCP. DSCP 3 was not configured.
To Next Page
Loading...
