Cisco SPS2024 - Show Interfaces Port-Channel

Port Channel Commands
show interfaces port-channel
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 263
21
Example
The following example forces port e1 to join port-channel 1 without an LACP
operation.
Console(config)# interface ethernet e1
Console(config-if)# channel-group 1 mode on
show interfaces port-channel
The show interfaces port-channel Privileged EXEC mode command displays port-
channel information.
Syntax
show interfaces port-channel [ port-channel-number ]
Parameters
•
port-channel-number — Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.