Ethernet Configuration Commands
port storm-control unknown-unicast fastethernet enable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 178
12
Example
The following example enables counting Multicast packets in the port storm-
control broadcast rate command.
Console(config)# port storm-control include-multicast
port storm-control unknown-unicast fastethernet enable
The port storm-control unknown-unicast fastethernet enable Global Configuration
mode Command enables unknown unicast storm control for FE ports. Use the no
form of this command to disable storm control.
Syntax
port storm-control unknown-unicast fastethernet enable
no port storm-control unknown-unicast fastethernet enable
Default Configuration
Unknown unicast storm control for FE ports are disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the port storm-control unknown-unicast fastethernet rate Global
Configuration mode command to the set the maximum rate.
The control for GE ports is per port and described in the port storm-control
include-multicast interface configuration command.
To Next Page
Loading...
