802.1x Commands
dot1x timeout quiet-period
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 522
36
User Guidelines
There are no user guidelines for this command.
Example
The following command manually initiates a re-authentication of 802.1x-enabled
Ethernet port e16.
Console# dot1x re-authenticate ethernet e16
dot1x timeout quiet-period
The dot1x timeout quiet-period Interface Configuration mode command sets the
number of seconds that the device remains in the quiet state following a failed
authentication exchange (for example, the client provided an invalid password).
Use the no form of this command to restore the default configuration.
Syntax
dot1x timeout quiet-period
seconds
no dot1x timeout quiet-period
Parameters
•
seconds —
Specifies the time in seconds that the device remains in the
quiet state following a failed authentication exchange with the client.
(Range: 0-65535 seconds)
Default Configuration
Quiet period is 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
To Next Page
Loading...
