Cisco SPS2024 - Show Spanning-Tree

Spanning Tree Commands
show spanning-tree
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 392
28
show spanning-tree
The show spanning-tree Privileged EXEC mode command displays spanning-tree
configuration.
Syntax
show spanning-tree [ethernet interface -number | port-channel port-channel-
number
] [instance instance-id ]
show spanning-tree [detail] [active | blockedports] [instance
instance-id ]
how spanning-tree mst-configuration
Parameters
•
interface -number — A valid Ethernet port.
• port-channel-number — A valid port channel number.
• detail — Indicates detailed information.
• active — Indicates active ports only.
• blockedports — Indicates blocked ports only.
• mst-configuration — Indicates the MST configuration identifier.
• instance-id — Specifies ID of the spanning tree instance. (Range: 1-7)
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.