Cisco SPS2024 - Show Class-Map

QoS Commands
show class-map
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 271
23
The Class-Map Configuration mode enables entering up to two match Class-map
Configuration mode commands to configure the classification criteria for the
specified class. If two match Class-map Configuration mode commands are
entered, each should point to a different type of ACL (e.g., one to an IP ACL and
one to a MAC ACL). Since packet classification is based on the order of the
classification criteria, the order in which the match Class-Map Configuration mode
commands are entered is important.
If there is more than one match statement in a match-all class map and the same
classification field appears in the participating ACLs, an error message is
generated.
NOTE A class map in match-all mode cannot be configured if it contains both an IP ACL
and a MAC ACL with an ether type that is not 0x0800.
Example
The following example creates a class map called class1 and configures it to
check that packets match all classification criteria in the class map match
statement.
Console(config)# class-map class1 match-all
Console(config-cmap)#
show class-map
The show class-map Privileged EXEC mode command displays all class maps.
Syntax
show class-map [ class-map-name ]
Parameters
•
class-map-name — Specifies the name of the class map to be displayed.