Cisco SPS2024 - Lacp Port-Priority

LACP Commands
lacp port-priority
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 236
17
Example
The following example configures the system priority to 120.
Console(config)# lacp system-priority 120
lacp port-priority
The lacp port-priority Interface Configuration (Ethernet) mode command
configures physical port priority. Use the no form of this command to return to the
default configuration.
Syntax
lacp port-priority value
no lacp port-priority
Parameters
•
value — Specifies port priority. (Range: 1-65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.