Cisco SPS2024 - Show Copper-Ports Cable-Length

PHY Diagnostics Commands
show copper-ports cable-length
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 256
20
Example
The following example displays information on the last TDR test performed on all
copper ports.
Console# show copper-ports tdr
Port Result Length (meters) Date
---- ------ --------------- ----
e1 OK
e2 Short 50 13:32:00 23 July 2005
e3 Test has not been performed
e4 Open 64 13:32:00 23 July 2005
e5 Fiber - -
show copper-ports cable-length
The show copper-ports cable-length Privileged EXEC mode command displays
the estimated copper cable length attached to a port.
Syntax
show copper-ports cable-length [ interface ]
Parameters
•
interface — A valid Ethernet port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode