Syslog Commands
logging
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 421
30
Example
The following example enables logging error messages.
Console(config)# logging on
logging
The logging Global Configuration mode command logs messages to a syslog
server. Use the no form of this command to delete the syslog server with the
specified address from the list of syslogs.
Syntax
logging {
ip-address
|
hostname
} [port
port
] [severity
level
] [facility
facility
]
[description
text
]
no logging {
ip-address
|
hostname
}
Parameters
•
ip-address
— IP address of the host to be used as a syslog server.
•
hostname
— Specifies the host name of the syslog server. (Range: 1-158
characters)
•
port
— Specifies the port number for syslog messages. (Range: 1-65535)
•
level
— Specifies the severity level of logged messages sent to the syslog
servers. Possible values: emergencies, alerts, critical, errors, warnings,
notifications, informational and debugging.
•
facility
— Specifies the facility that is indicated in the message. Possible
values: local0, local1, local2, local3, local4, local5, local 6, ocal7.
•
text
— Syslog server description. (Range: 1-64 characters)
Default Configuration
The default port number is 514.
The default logging message level is informational.
To Next Page
Loading...
