Cisco SPS2024 - Switchport Customer Vlan

VLAN Commands
switchport customer vlan
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 497
34
switchport customer vlan
The switchport customer vlan Interface Configuration (Ethernet, port-channel)
mode command sets the port’s VLAN when the interface is in customer mode. Use
the no form of this command to restore the default configuration.
Syntax
switchport customer vlan vlan-id
no switchport customer vlan
Parameters
•
vlan-id — VLAN ID of the customer.
Default Configuration
No VLAN is configured.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures Ethernet port 1 to discard untagged frames at
ingress.
Console(config)# interface ethernet 1
Console(config-if)# switchport customer vlan