Cisco SPS2024 - Class

QoS Commands
class
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 274
23
Command Mode
Global Configuration mode
User Guidelines
Before configuring policies for classes whose match criteria are defined in a class
map, use the policy-map Global Configuration mode command to specify the
name of the policy map to be created or modified.
Class policies in a policy map can only be defined if match criteria has already
been defined for the classes. Use the class-map Global Configuration and match
Class-map Configuration commands to define the match criteria of a class.
Only one policy map per interface per direction is supported. A policy map can be
applied to multiple interfaces and directions.
Example
The following example creates a policy map called ‘policy1’ and enters the Policy-
map Configuration mode.
Console (config)# policy-map policy1
Console (config-pmap)#
class
The class Policy-map Configuration mode command defines a traffic classification
and enters the Policy-map Class Configuration mode. Use the no form of this
command to remove a class map from the policy map.
Syntax
class class-map-name [access-group acl-name ]
no class
class-map-name