802.1x Commands
Advanced Features
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 535
36
Advanced Features
dot1x auth-not-req
The dot1x auth-not-req Interface Configuration (VLAN) mode command enables
unauthorized devices access to the VLAN. Use the no form of this command to
disable access to the VLAN.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although only
tagged packets are accepted in the unauthorized state.)
Example
The following example enables access to the VLAN to unauthorized devices.
Console(config)# interface vlan 5
Console(config-if)# dot1x auth-not-req
To Next Page
Loading...
