Cisco SPS2024 - Snmp-Server Trap Authentication

SNMP Commands
snmp-server trap authentication
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 349
26
snmp-server trap authentication
The snmp-server trap authentication Global Configuration mode command
enables the device to send SNMP traps when authentication fails. Use the no form
of this command to disable SNMP failed authentication traps.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Default Configuration
SNMP failed authentication traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables SNMP failed authentication traps.
Console(config)# snmp-server trap authentication