Cisco SPS2024 - Snmp-Server Set

SNMP Commands
snmp-server set
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 352
26
snmp-server set
The snmp-server set Global Configuration mode command defines the SNMP MIB
value.
Syntax
snmp-server set variable-name name1 value1 [ name2 value2 …]
Parameters
•
variable-name — MIB variable name (Range 1-160 characters).
• name value — List of name and value pairs. In the case of scalar MIBs, only a
single pair of name values. In the case of an entry in a table, at least one pair
of name and value followed by one or more fields (Range 1-160 characters).
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Although the CLI can set any required configuration, there might be a situation
where a SNMP user sets a MIB variable that does not have an equivalent
command. In order to generate configuration files that support those situations, the
snmp-server set command is used.
This command is case-sensitive.
Example
The following example configures the scalar MIB sysName with the value LinkSys.
Console(config)# snmp-server set sysName sysname LinkSys