24
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 306
RADIUS Commands
radius-server host
The radius-server host Global Configuration mode command specifies a RADIUS
server host. Use the no form of this command to delete the specified RADIUS host.
Syntax
radius-server host {
ip-address
|
hostname
} [auth-port
auth-port-number
] [acct-
port
acct-port-number
] [timeout
timeout
] [retransmit
retries
] [deadtime
deadtime
]
[key
key-string
] [source
source
] [priority
priority
] [usage
type
]
no radius-server host {
ip-address
|
hostname
}
Parameters
•
ip-address
— IP address of the RADIUS server host.
•
hostname
— Hostname of the RADIUS server host. (Range: 1-158
characters)
•
auth-port-number —
Port number for authentication requests. The host is
not used for authentication if the port number is set to 0. (Range: 0-65535)
•
acct-port-number
— Port number for accounting requests. The host is not
used for accountings if set to 0.
•
timeout
— Specifies the timeout value in seconds. (Range: 1-30)
•
retries
— Specifies the retransmit value. (Range: 1-10)
•
deadtime
— Length of time in minutes during which a RADIUS server is
skipped over by transaction requests. (Range: 0-2000)
•
key-string
— Specifies the authentication and encryption key for all
RADIUS communications between the device and the RADIUS server. This
To Next Page
Loading...
