Cisco SPS2024 - Chapter 9: DHCP Relay Commands; Ip Dhcp Relay Enable (Global)

9
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 141
DHCP Relay Commands
ip dhcp relay enable (global)
The ip dhcp relay enable Global Configuration mode command enables Dynamic
Host Configuration Protocol (DHCP) relay features on your router. Use the no form
of this command to disable the relay agent features.
Syntax
ip dhcp relay enable
no ip dhcp relay enable
Default Configuration
DHCP is disabled on the router.
Command Mode
Global (Interface) Configuration mode
User Guidelines
This command is only functional if the device is in Router mode.
Example
The following example enables DHCP services on the DHCP Server.
Console(config)# ip dhcp relay enable