LACP Commands
lacp timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 237
17
Example
The following example defines the priority of Ethernet port e6 as 247.
Console(config)# interface ethernet e6
Console(config-if)# lacp port-priority 247
lacp timeout
The lacp timeout Interface Configuration (Ethernet) mode command assigns an
administrative LACP timeout. Use the no form of this command to return to the
default configuration.
Syntax
lacp timeout {long | short}
no lacp timeout
Parameters
•
long — Specifies the long timeout value.
• short — Specifies the short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
