ARP Inspection Commands
show ip arp inspection
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 72
4
Example
The following example configures the minimal interval between successive ARP
SYSLOG messages.
Console(config)# ip arp inspection logging interval
show ip arp inspection
The show ip arp inspection EXEC mode command displays the ARP inspection
configuration.
Syntax
show ip arp inspection [ethernet
interface
| port-channel
port-channel-number
]
Parameters
•
interface —
Specifies an Ethernet port.
•
port-channel-number —
Specifies a port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
EXEC
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
