Cisco SPS2024 - Show System Flowcontrol

Ethernet Configuration Commands
show system flowcontrol
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 158
12
Default Configuration
Off
User Guidelines
The command would be effective only after reset.
Command Mode
Global configuration
Examples
Console(config)# port jumbo-frame
show system flowcontrol
The command is for SPS2024 only.
Use the show system flowcontrol command to display the cascade ports
flowcontrol state.
Syntax
show system flowcontrol
Parameters
This command has no arguments or keywords.
Default Configuration
The command has no default configuration.