Cisco SPS2024 - Show Protected-Ports Fastethernet

VLAN Commands
show protected-ports fastethernet
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 501
34
1/2 Protected
1/3 Protected
1/4 Protected
show protected-ports fastethernet
Use the show protected-ports fastethernet EXEC command to show protected
ports configuration.
NOTE This command is supported in SPS2xx devices.
Syntax
show protected-ports fastethernet
Default Configuration
Defaults
Command Mode
EXEC
Example
Console> show protected-ports fastethernet
GE protected-ports state: Unprotected
FE protected-ports state: Protected