Cisco SPS2024 - Show Interfaces Status

Ethernet Configuration Commands
show interfaces status
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 167
12
Example
The following example displays the configuration of all configured interfaces:
Console# show interfaces configuration
Port Type Duplex Speed Neg Flow Admin Back Mdix
Ctrl State Pressure Mode
---- ---------- ------ ----- ------- ---- ----- -------- ----
1 100M-Copper Full 100 Enabled Off Up Disabled Auto
2 100M-Copper Full 100 Enabled Off Up Disabled Auto
3 100M-Copper Full 100 Enabled Off Up Disabled Auto
4 100M-Copper Full 100 Enabled Off Up Disabled Auto
5 100M-Copper Full 100 Enabled Off Up Disabled Auto
6 100M-Copper Full 100 Enabled Off Up Disabled Auto
7 100M-Copper Full 100 Enabled Off Up Disabled Auto
8 100M-Copper Full 100 Enabled Off Up Disabled Auto
9 100M-Copper Full 100 Enabled Off Up Disabled Auto
10 100M-Copper Full 100 Enabled Off Up Disabled Auto
11 100M-Copper Full 100 Enabled Off Up Disabled Auto
show interfaces status
The show interfaces status Privileged EXEC mode command displays the status
of all configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number |]
Parameters
•
interface — A valid Ethernet port.
• port-channel-number — A valid port-channel number.