VLAN Commands
switchport customer multicast-tv vlan
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 498
34
switchport customer multicast-tv vlan
The switchport customer multicast-tv vlan interface configuration command
enables the receiving of Multicast transmissions from a VLAN that is not the
Customer port’s VLAN, while keeping the L2 segregation with subscribers on
different Customer port VLANs.
Syntax
switchport customer multicast-tv vlan {add
vlan-list
| remove
vlan-list
}
Parameters
•
vlan-list —
List of Multicast TV VLANs.
Default Configuration
The port is not member in any Multicast TV VLAN.
Command Mode
Interface configuration (Ethernet, port-channel).
Command Usage
The user cannot transmit Multicast transmissions on Multicast TV VLANs.
Example
The following example configures port e1 to enable receiving Multicast
transmissions from a VLAN that is not the customer port’s VLAN.
Console (config-if)# switchport customer multicast-tv vlan add
3000
To Next Page
Loading...
