Cisco SPS2024 - Show Qos Interface

QoS Commands
show qos interface
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 291
23
Example
The following example limits the rate of the incoming traffic.
Console(config)# interface ethernet e5
Console(config-if) rate-limit
show qos interface
The show qos interface Privileged EXEC mode command displays Quality of
Service (QoS) information on the interface.
Syntax
show qos interface [buffers | queuing | policers | shapers | rate-limit] [Ethernet
interface-number | vlan vlan-id | port-channel number ]
Parameters
•
ethernet interface-number — Valid Ethernet port number.
• lan vlan-id — VLAN number.
• port-channel number — Valid port-channel number.
• buffers — Displays buffer setting for the interface’s queues. For gigabit
Ethernet displays, the queue depth for each of the 8 queues and the
thresholds for the WRED/Tail Drop. For 10/100 displays the minimum
reserved setting.
• queuing — Displays the queue’s strategy (WRR or EF) and the weight for
WRR queues and the CoS to queue map and the EF priority.
• policers — Displays all the policers configured for this interface, their
setting, and the number of policers currently unused.
• shapers — Displays the shaper of the specified interface and the shaper for
the queue on the specified interface.
• rate-limit — Displays the rate-limit configuration.