Cisco SPS2024 - Chapter 29: SSH Commands; Ip Ssh Port

29
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 403
SSH Commands
ip ssh port
The ip ssh port Global Configuration mode command specifies the port to be
used by the SSH server. Use the no form of this command to restore the default
configuration.
Syntax
ip ssh port port-number
no ip ssh port
Parameters
•
port-number — Port number for use by the SSH server (Range: 1-65535).
Default Configuration
The default port number is 22.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.