Line Commands
show line
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 245
18
Example
The following example configures the interval that the system waits until user input
is detected to 20 minutes.
Console(config)# line console
Console(config-line)# exec-timeout 20
show line
The show line Privileged EXEC mode command displays line parameters.
Syntax
show line [console | telnet | ssh]
Parameters
•
console — Console terminal line.
• telnet — Virtual terminal for remote console access (Telnet).
• ssh — Virtual terminal for secured remote console access (SSH).
Default Configuration
If the line is not specified, the default value is console.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
