Cisco SPS2024 - Chapter 3: ACL Commands; Ip Access-List

3
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 48
ACL Commands
ip access-list
The ip access-list Global Configuration mode command enables the IP-Access
Configuration mode and creates Layer 3 ACLs. To delete an ACL, use the no form
of this command.
Syntax
ip access-list access-list-name
no ip access-list access-list-name
Parameters
•
access-list-name — Specifies the name of the ACL. (Range: 0-32
characters) Use “” for empty string.
Default Configuration
The default for all ACLs is deny-all.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.