Cisco SPS2024 - Set

QoS Commands
set
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 279
23
set
The set Policy-map Class Configuration mode command sets new values in the IP
packet.
Syntax
set {dscp new-dscp | queue queue-id | cos new-cos }
no set
Parameters
•
new-dscp — Specifies a new DSCP value for the classified traffic. (Range:
0-63)
• queue-id — Specifies an explicit queue ID for setting the egress queue.
• new-cos — Specifies a new user priority for marking the packet. (Range: 0-
7)
NOTE NOTE: In SPS2xx ‘set cos’ command will not affect regular IP traffic, it will affect only
non IP traffic, unless the outgoing port is Gigabit port
Default Configuration
This command has no default configuration.
Command Mode
Policy-map Class Configuration mode
User Guidelines
This command is mutually exclusive with the trust Policy-map Class Configuration
command within the same policy map.