Cisco SPS2024 - Qos Dscp-Mutation

QoS Commands
qos dscp-mutation
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 301
23
Default Configuration
Default CoS value of a port is 0.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If the port is trusted, the default CoS value of the port is used to assign a CoS value
to all untagged packets entering the port.
Example
The following example configures port e15 default CoS value to 3.
Console(config)# interface ethernet e15
Console(config-if) qos cos 3
qos dscp-mutation
The qos dscp-mutation Global Configuration mode command applies the DSCP
Mutation map to a system DSCP trusted port. Use the no form of this command to
restore the trust state with no DSCP mutation.
Syntax
qos dscp-mutation
no qos dscp-mutation
Default Configuration
This command has no default configuration.