Cisco SPS2024 - Radius-Server Retransmit

RADIUS Commands
radius-server retransmit
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 309
24
radius-server retransmit
The radius-server retransmit Global Configuration mode command specifies the
number of times the software searches the list of RADIUS server hosts. Use the no
form of this command to reset the default configuration.
Syntax
radius-server retransmit retries
no radius-server retransmit
Parameters
•
retries — Specifies the retransmit value. (Range: 1-10)
Default Configuration
The software searches the list of RADIUS server hosts 3 times.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the number of times the software searches all
RADIUS server hosts to 5 times.
console(config)# radius-server retransmit 5